FLEXMAR polyaspartic flooring can be quickly applied in one day, year-round, allowing greater installation flexibility
  • Enjoy an easier application with an 11 to 15 minute working time
  • Recoat and walk-on in 1 hour or less
  • Return to service in 1 to 2 hours
  • Apply and cure in temperatures as low as -30F (-35C) and as high as 150F (66C)
  • Complete projects virtually year-round through varying weather conditions and seasonal changes
  • Apply to most existing coatings and sealers after proper preparation

  • Here's How It's Done: 1.

    The surface is prepared with diamond grinders.

    The surface is prepared
  • Here's How It's Done: 2.

    Any cracks and surface defects are repaired.

    Cracks and surface defects are repaired
  • Here's How It's Done: 3.

    The two components of the pre-pigmented FLEXMAR coating system (Part A and Part B) are mixed in a 1:1 ratio. There are no packets of pigment paste to add, no solvents to add.

    FLEXMAR coating system are mixed
  • Here's How It's Done: 4.

    A solid-color FLEXMAR base coat is tight-rolled onto the prepared concrete surface.

    Example application time: 20 minutes

    Solid-color FLEXMAR base coat
  • Here's How It's Done: 5.

    Decorative vinyl chips are immediately broadcast into the still-wet FLEXMAR base coat.

    Decorative vinyl chips are broadcast
  • Here's How It's Done: 6.

    About 1 hour later, any loose vinyl chips are removed from the floor.

    Loose vinyl chips are removed
  • Here's How It's Done: 7.

    Then, an initial coat of FLEXMAR clear sealer is applied on top of the vinyl chip layer.

    Example application time: 20 minutes
    Example dry time: 1 hour

    FLEXMAR clear sealer is applied
  • Here's How It's Done: 8.

    About 1 hour later, a second finish coat of FLEXMAR clear is applied. Slip-reduction media can be broadcast into this still-wet finish coat, if desired.

    Example application time: 20 minutes
    Example dry time: 1 hour

    Second finish coat of FLEXMAR clear is applied
  • Here's How It's Done: 9.

    In as little as 1 to 2 hours after the finish coat is applied, the floor can be walked on and returned to service.

    Returned to service
Want to See More? Check out our Videos page!